[Elecraft] K3 and N1MM Logger

[Mike]

  Congrats, Tom.

Do you have the K3 baud rate set to match? CONFIG:RS232? I have N/8/2 for the other 
parms.

Can you connect to the K3 using the K3 utility?

I'm a bit confused if you're having trouble with keying also, or just with the 
freq/mode stuff.

73, Mike

On 8/3/2010 8:05 AM, Tommy Alderman wrote:
> I just received a new factory wired K3 (s/n 4521) and I can not get the
> K3/Logger to talk to each other. At this point I think the problem with the
> K3 (and it's user!) but I am not sure.
> Prior to setting up my K3, I had been using an IC-7700, keying with COM1 and
> interfacing with COM3, so I know those ports were working. I have a home
> brew keying circuit that works with various other programs, so I have no
> need to key the K3 through its serial port.
> What I have done is moved my keying circuit (it works fine with the K3) to
> the K3 and moved my COM3 serial cable to the K3. In Logger Config, I changed
> from the IC-7700 to K3, I used the recommended configuration for the K3,
> i.e., 19600/N/8/1 and I have DTR and RTS set to 'Always OFF'. The CW/PTT
> Port Adr is set for 3E8.
> I have tried numerous other settings, N1MM recognizes it is connected to a
> K3, but I get no frequency readout.
> Sure would appreciate some constructive suggestions or some working
> configuration settings!
> Tom - W4BQF
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html