[Elecraft] K3 and Split

[Joe Subich, W4TV]

> I have my K3 linked to my computer and the DX Cluster, and I have 
> also noticed that if I am on, say 7005kHz in split mode, and a 'spot' 
> appears on the Cluster on, say 7009kHz, if I click on the spot to 
> send the K3 to that frequerncy, then once again it drops out of split 
> mode and reverts to normal mode. 

That is a function of your logging program.  If the logging program 
commands both VFO A and VFO B it will be correct.  The logger must 
be turning off split as simply sending a set VFO A and set MODE 
commands will not take the K3 out of split unless the new frequency 
is on a different band (the K3 will not do split across bands). 

73, 

   ... Joe, W4TV 
  


> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Chris Page
> Sent: Wednesday, September 30, 2009 12:31 PM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] K3 and Split
> 
> 
> Help please!
> 
> Does anyone know of a way to enable the K3 so that when you change 
> bands, it stays in split mode?
> 
> I only operate CW and like using the K3 in split mode, but find it 
> frustrating when I change to another band, the K3 goes back to normal 
> mode.
> 
> I have my K3 linked to my computer and the DX Cluster, and I have 
> also noticed that if I am on, say 7005kHz in split mode, and a 'spot' 
> appears on the Cluster on, say 7009kHz, if I click on the spot to 
> send the K3 to that frequerncy, then once again it drops out of split 
> mode and reverts to normal mode.  Is there any way round this, so the 
> K3 stays in split mode, please?
> 
> Thanks and 73 de Chris, G4BUE 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html