[Elecraft] VFO Tunning Noise Reduction MOd

[Dave G4AON]

Larry, use solder wick to clear the hole first. It makes a neater job
and reduces the risk of excess solder dropping through the other side of
the board when soldering a component in.

73 Dave, G4AON
K3/100 #80
==============
I have my K3- S/N 3278 open on the bench to do this mod.
I find the via holes near C66 not open. They have been soldered from the
other side.
Is this an indication that this mod was down before it ship to me 7/10/09??
Or should I just tack on the resistor/diode to them?

de K2GN/Larry
K3 - S/N 3278