[Elecraft] Central Tendency of K2 PCB Solder Pad Widths?

[Jeff T. Casey]

Hi gang,

This document on the Elecraft web site,
http://bit.ly/solderingtips
says,
"[Soldering iron] tip width will normally be in the range of 1/32" (0.79mm) through 1/8" (3.2mm), depending upon the width of the pad to which you are soldering. The width of the tip selected should be about 75% to 90% of the width of the pad."

What would you estimate to be the median or modal (or just typical ;-) solder pad width on the K2's circuit boards?

Or, to be more direct, which of the following soldering tip widths would be best for use in building a K2: 0.80 mm, 1.19 mm, 1.60 mm, or 2.40 mm?

Or am I just splitting hairs?

Thanks very much, 73 & 72,
Jeff
NE2J (formerly WB5GWB)