[Elecraft] K3 new GAIN knobs

[Mike]

Sorry, but I have to meet my reading tutor now. I misread the thread. I 
blame it on that speed reading course I never took. :-[

I'm referring to the 4 knob set [shift,width,speed,cmp].

Mike NF4L


Grant Youngman wrote:
> On Oct 28, 2009, at 4:13 PM, Mike wrote:
>
>   
>> My kit came with the new knobs. They don't seem to go onto the shaft
>> very far. So far no breakage, but two different ones have come of  
>> while
>> I was turning them.
>>     
>
>
> Maybe just tighten them a bit more?  Best way to get them really deep  
> on the shaft is to hit 'em with a hammer :-)   (Please don't do that.   
> Sometimes I feel like you can't make any comment on a reflector  
> without an appropriate disclaimer)
>
> Shoot, I haven't any trouble with my original concentric knobs  
> (shipped on ser 2091).  I didn't pull a hamstring tightening them  
> down, and they don't fall off either :-)
>
> Grant/NQ5T
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>