[Elecraft] Elecraft] K3 PB Ctrl Shift .01/.05

[Jim Miller KG0KP]

The bandwidth appears to be limited when using 10 hz and it is painfully 
slow when the bandwidth is fairly wide.

When I am in PSK or RTTY and using search and pounce, I use wide bandwidth 
in HRD and DM780 to find the signal I want on the screen and then narrow it 
in so it is better for me to have 50 when wide and then 10 when much 
narrower so I wind up switching all the time.

What would be really nice, if possible, is to auto change to 10 hz shift 
when you adjust your width below (pick a  number) 200 or so and back when 
you go above that width (optionally?).

(A single button would work too, guess I will have to figure out how to do 
that.)

Thanks es 73, de Jim KG0KP

----- Original Message ----- 
From: "Joe Subich, W4TV" <lists at subich.com>

> The only problem is that 10Hz steps limit the range of Fc ...
> when Wayne eliminates or relaxes the restriction, you will be
> correct as far as operation with Commander is concerned.  Now,
> If Wayne would add a "set" command to allow direct access to
> 10/50 Hz, perhaps we could convince Dave to link the radio
> button to it <G>.
>
> 73,  ... Joe, W4TV