[Elecraft] K2 #5312 lo battery indication

[Don Wilhelm]

John,

If your power supply is up to par, then --
IF your K2 is below SN 3000 - look at the switch on the top of the 
control board (to the right of center).  If its handle has been bumped 
out of the INT position (toward the center of the control board), that 
will cause a LO BATT indication.
OTOH, IF your SN is above 3000, there is a 3 pin header in place of the 
switch - make certain the jumper is present and is plugged into the two 
pins closest to the center of the control board.  The pins and jumper do 
the same as the  switch, but are not as easily accidentally bumped when 
the top cover is open.

73,
Don W3FPR

John Wiener wrote:
> Hello everyone.
>
>
> Just started to notice LO BATT indication while using digital modes  
> on xmit...beep heard along with the LO BATT on display.  I am on a  
> power supply and even my signalink is NOT battery operated.  What  
> does this mean?
> The voltage from the Daiwa power supply is right on 12 VDC throughout.
>
> Thanks!
>
> John
> AB8O
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.423 / Virus Database: 270.14.31/2457 - Release Date: 10/24/09 14:31:00
>
>