[Elecraft] re: DSP red light coming on at max load [fixed]

[Wayne Burdick]

I wrote:

> I get a continuous DSP red LED and distorted audio under
> the following conditions....

A few of you have asked me what the "DSP red LED" is for. This is an  
LED on the top edge of the DSP board that lights up to remind your  
humble firmware crew when we've made a mistake that causes the DSP to  
run out of cycles.

A couple of our field testers had noticed a "stuck" switch feedback  
tone when turning NR on/off, etc., and sure enough, the DSP's LED was  
coming on solid (as opposed to a brief flash, which is OK). This has  
now been corrected, and we should have a new beta release very shortly.

73,
Wayne
N6KR