[Elecraft] K3 Filter problem Part II

[Wayne Burdick]

SIG RMV does not move "real" signals. It shifts the internal signal  
sources such that the net is zero. All you will hear is a slight  
change in filter center pitch.

That said, it should, as you noted be used after checking cable  
orientation.

73,
Wayne
N6KR

----
http://www.elecraft.com

On Oct 12, 2009, at 7:47 AM, Richard Ferch <ve3iay at storm.ca> wrote:

> Bill W4ZV wrote:
>> Bill W4ZV wrote:
>>>
>>> Have you tried CONFIG: SIG RMV?
>>>
>>
>> This was implemented in MCU 3.03 / DSP 2.10,  
>> 3-17-2009...documentation here:
>>
>> http://www.elecraft.com/K3/k3_software.htm
>>
>> (K3 Firmware Release Notes, just above "New Firmware Load  
>> Information")
>>
>> 73,  Bill
>
> Warning: CONFIG:SIG RMV can have side effects. In addition to moving
> fast-moving birdies right outside the bandpass, effectively  
> eliminating
> them, it also moves real signals by a smaller amount.