[Elecraft] V3.41 NR tone

[Steven Zabarnick]

I’d like someone with a similar K3 configuration to help me diagnose  
a problem by doing a test.

Required K3 configuration:
Filters- 2.7 kHz in FL1 and 500 kHz in FL2
KAT3 ATU
KXV3
KPA3 100 watt amp
V3.41 firmware

In cw mode, set your filter width to greater than 500 Hz to engage the  
2.7 kHz filter in FL1. In the Config Menu set SW TONE to ON. Set the  
NR to FL1-1, and cycle the NR on and off.

Do you hear a continuous tone when NR is cycled on?

Thanks.

Steve N9SZ