[Elecraft] [K3] Fw: New 3.41 IMPROVED RX LOW-FREQUENCY RESPONSE in AM/SSB/CW MODES

[TomB W1PKX]

In AM receive I don't see any difference with previous (3.30) release. The
50 Hz RX EQ slider has no effect as before. I haven't measured it, but the
Low cutoff still seems to be ~100 Hz.

I notice in AM, with SHIFT=1.50,LO=0.00and width=5.00 the HI shows 4 Khz. I
don't understand that. If I set SHIFT=1.7 then the HI goes to 4.2 Khz. In AM
I have the FM filter selected.


Tom


mark roz wrote:
> 
> 
> Went back to 3.30 and LOW FREQ resp. is about the same.
> Anybody else?
> --- On Tue, 10/6/09, mark roz <anegadasail at yahoo.com> wrote:
> 
> 
> From: mark roz <anegadasail at yahoo.com>
> Subject: New 3.41 IMPROVED RX LOW-FREQUENCY RESPONSE in AM/SSB/CW MODES
> To: "Elecraft" <elecraft at mailman.qth.net>
> Date: Tuesday, October 6, 2009, 5:15 PM
> 
> 
> 
> 
> 
> 
> 
> K3 set to DSP width 4kHz and I'm using very good headphones.
> No difference with low freq. response.
> What is the problem?
> Mark 
> 
> 
> 
>       
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> 
> 



-- 
View this message in context: http://n2.nabble.com/Fw-New-3-41-IMPROVED-RX-LOW-FREQUENCY-RESPONSE-in-AM-SSB-CW-MODES-tp3778976p3784671.html
Sent from the [K3] mailing list archive at Nabble.com.