[Elecraft] Default Settings for K-3?

[Ron Midwin]

Gentlemen:

 

Re my K-3, S/N 1997;

 

I just downloaded and installed 

MCU 3.41 / DSP 2.37, 10-02-2009

And also the latest Utility, K3 Utility (1.2.9.30)

 

Everything sounds OK, and seems to work, but I'm wondering if there is a way
to set the radio to the "default" settings?  I've made so many adjustments
since I've had the K-3, I would like to see how far I'm off from the
"factory settings"?

 

BTW I have just the main receiver.

 

I've seen several recommendations on this link to optimize various features,
but it would be nice if I could go back to the default, and then play with
features and save them.

 

I see there is a save settings tab in the utility.  Is this where most
operators save various setups?

 

Re the RF Gain Calibration, I don't have an XG2, so is doing this
calibration useful?

 

RF GAIN CALIBRATION PROCEDURE UPDATED: You?ll need the

latest revision of K3 Utility and a 50-microvolt signal source (e.g.,  

an XG2).

 

Thanks,

 

 

Ron Midwin

AE6RH

S/N 1997