[Elecraft] [K3] K3 command mode default k30 k31

[Laurent F6DEX]

Hello,

1) Data sub mode is reported (see DT command GET/SET). It is always possible
to know the mode in use with the K3 exactly. The MD command is compatible
with Kenwood protocol. Adding sub mode to IF string is not a good solution
since it breaks the compatibility. DT must be used.

2) About K31... It is a non-issue. A software can easily send K3 at startup
but has also to repeat this command in case of the K3 is powered Off. It is
different with an external controller (it does not work like a software) ;
In the case of the Microham, it must be programmed for adding K31 in front
of any command. The lenght of the command is increased by only 4 Bytes. You
should suggest this tip to the developper.

73,

Laurent F6DEX



-- 
View this message in context: http://n2.nabble.com/K3-command-mode-default-k30-k31-tp3752716p3756295.html
Sent from the [K3] mailing list archive at Nabble.com.