[Elecraft] K2 - CONTROL PANNEL FREEZE UP (K7CJA)

[CJA]

I have a K2 with a KPA100 and KAT100 in a separate enclosure.  It had been
working on my lossey loop but I decided to try a ground mounted Hi-Q 4/160. 
After connecting the antenna, I began trying to tune to the various bands. 
It seemed to be tuning to a low SWR when the control panel just froze up. 
The VFO would not change the freq and none of the buttons functioned.  I
turned it off and on several times and came up with the full elecraft in the
LCD and then the last freq I was on.  The control panel was still frozen.  I
then tried to reset.  That did not work.  Now it just goes through the POST
(full elecraft in the LCD) and seems to go into transmit (dummy load
connected) with a high pitched tone and hangs there.  Any suggestions would
be greatly appreciated.  73, Chris Amyes, K7CJA
-- 
View this message in context: http://n2.nabble.com/K2-CONTROL-PANNEL-FREEZE-UP-K7CJA-tp3749758p3749758.html
Sent from the Elecraft mailing list archive at Nabble.com.