[Elecraft] K3 Utility Versoin 1.2.10.27 is now available on Elecraft web site.

[Lyle Johnson]

> ...  So perhaps it was reset to "Not inst" 
> after loading the new firmware, but why would loading the new firmware 
> cause such a change?

I can't explain why it might happen, but on occasion after a firmware 
load, especially one that is moving up several generations, it is 
possible a config parameter might be altered.

I suspect if you reloaded the new firmware, and experienced the same 
unexpected status of the ATU, it could be remedied through the CONFIG menu.

Also, after a major upgrade, and once you see all is working properly, I 
recommend doing a configuration save using K3 Utility.

73,

Lyle KK7P