[Elecraft] K3 Production Firmware Release (3.63)

[hb9ari]

Don,

Thank you for your quick reply.

I will leave the default setting to SPI1
as explained and load the new firmware.

May be the hardware mod(s) during this Winter...

My best 73,
Rudolf  HB9ARI

Don Wilhelm wrote:
> Rudolf,
>
> Yes, you can safely upgrade without adding hardware mods.
> You must leave CONFIG: VFO MD set to SPI1 (default) until after the K3 
> VFO Noise Reduction  Mod has been installed.
> That mod is not difficult - just 2 diodes and 2 resistors (all leaded 
> parts).
>
> 73,
> Don W3FPR
>
> hb9ari wrote:
>> Hello,
>>
>> Since ~ 1 year, i 've not upgraded the firmware.
>> (K3#1212) should be 2.56 ??? (i'm at office...)
>>
>> My question: As i've never done hardware
>> modifications, can the FW 3.63 be installed
>> without problem?
>>
>> Thank you for your help!
>>
>> 73 QRO fr Rudolf, HB9ARI
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> ------------------------------------------------------------------------
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - www.avg.com Version: 9.0.709 / Virus Database: 
>> 270.14.78/2521 - Release Date: 11/23/09 02:52:00
>>
>>   
>