[Elecraft] TX/RX on vfo B with SUB rx?

[Barry N1EU]

Mark n2qt wrote:

>Is it possible to use vfo B to set both the tx and rx freq?   I've got an idea about using the IF output for mult. searching, which would require using VFO B to set tx/rx using the sub rx.    Alternately can I get to the IF output from the SUB RX?

The short answer to the first question is yes.  You use split transmit
mode and then vfoB will control both the tx and subrx.  N1MM Logger
supports this mode of operation (SO2V) in the K3 without too many
wrinkles.

73,
Barry N1EU