[Elecraft] K3: AGC turns itself off while in config menu

[Julian, G4ILO]

I was adjusting the LIN OUT level while running CW Skimmer this morning and
the volume from the K3 suddenly went very loud. When I checked, I found that
the AGC had been disabled.

Upon investigation there appears to be an issue with software polling the K3
while in the menu. I can almost guarantee that the AGC will be disabled if I
go into the menu while a program is connected and polling the K3. You might
wait a few seconds or a few minutes before it happens, though.

I haven't had this occur when not in the menu. nor with the menu selected
but no CAT software running. I'm using the latest beta (3.57) and a serial
connection of 38400 baud.

-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://n2.nabble.com/K3-AGC-turns-itself-off-while-in-config-menu-tp3992827p3992827.html
Sent from the Elecraft mailing list archive at Nabble.com.