[Elecraft] K3 bottom cover screw spinning in place

[Ron D'Eau Claire]

That works *if* there's no subreceiver installed. Otherwise one must remove
the subrx module and cables to get to it. 

Ron AC7AC

-----Original Message-----
  Just take the top cover off and you will see a
screw just ahead of the PA box in the center of the rig. Remove it and then
the bottom will come off.  Both of those screws go into a stand off.
Replace the top screw with the stand off on the bottomef and tighten it a
bit more firmly.  Then you can replace the bottom cover.  Tighten it a
little less. 

 
73,

-Robby VY2SS

 

 

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html