[Elecraft] [K3] Noise Clicks...still!

Doug Alspaugh dalspaugh at comcast.net
Sun Nov 1 10:02:20 EST 2009


Hi Tom,

Yes, after saying I did not hear them I just this moment did hear them in my 
out board speaker. Looks like a CW sig needs to be present before I hear 
them, but they are very prominent


73 Doug N3QW
----- Original Message ----- 
From: "tom_k1tl" <k1tl at cox.net>
To: "Doug Alspaugh" <dalspaugh at comcast.net>
Sent: Sunday, November 01, 2009 9:17 AM
Subject: RE: [Elecraft] [K3] Noise Clicks...still!


> Hi Doug,
>
> Seems that I did not have this b4 the 3.44fw update and since then I have
> been hearing the "clix" in the headset...almost sounds like "key clix."
>
> It might also be that I have a bad decoder pot as one signal did change 
> freq
> while I was tuning thru the steps. It did not show up on the freq display 
> of
> the K3 tho.
>
> I sure hope that it is not the encoder piece as the fp is a pain in the 
> a**
> to put back together due to the LED's not lining up properly at times. I
> have no problem doing the pc work as I am all equipped here in the shack 
> for
> that kind of stuff.
>
> 73
> Tom/k1tl...
>
> -----Original Message-----
> From: Doug Alspaugh [mailto:dalspaugh at comcast.net]
> Sent: Sunday, November 01, 2009 9:02 AM
> To: tom_k1tl; elecraft at mailman.qth.net
> Subject: Re: [Elecraft] [K3] Noise Clicks...still!
>
>
> Could you just be hearing the width steps. That is all I hear here.
>
>
> 73 Doug N3QW
>
>
> ----- Original Message -----
> From: "tom_k1tl" <k1tl at cox.net>
> To: <elecraft at mailman.qth.net>
> Sent: Sunday, November 01, 2009 8:45 AM
> Subject: [Elecraft] [K3] Noise Clicks...still!
>
>
>> Hi Gang,
>>
>> Had problem with "noise clicks" while using the width control before this
>> latest fw upgrade. I thought that this was supposed to be addressed with
>> the
>> latest fw. I have 3.52 installed and still have clicks in the headphones
>> when adjusting the width control.  I thought it might be caused by some 
>> of
>> the stations that were loud, due to the close proximity of the signals 
>> but
>> did not have this before 3.44 fw.
>>
>> Has anybody else have similar problems with this "artifact"?
>>
>> 73
>> Tom/k1tl...
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> 



More information about the Elecraft mailing list