[Elecraft] RES: UPGRADE VERSION 3.11

[py5eg]

Hi aki
I´m using a standard serial port directly connected to the K3.
73
Oms

________________________________

De: a yoshida [mailto:ayoshida at my.email.ne.jp]
Enviada: qua 27/5/2009 19:41
Para: py5eg
Cc: elecraft at mailman.qth.net
Assunto: Re: [Elecraft] UPGRADE VERSION 3.11



Atilano

If you are using USB interface then try legacy COM port.
Some kind of USB interface cause this problem.

73
aki  ja1nlx


py5eg wrote:
> Hi Folks:
> 
> During a upgrade procedure of one of my K3 to version 3.11 a malfunction has occurred
> 
> 1) A message asking to turn the K3 of and on again to continue the upgrade
> 2) I tried to turn of and didn´t succeed
> 3) I turned the power supply off and turned on again,and turned the K3 on
> 4) The process crushed and with the display was off  with  "MCU LD"
> 5) The TX led blinking and no way to turn off
> 
> What should I do?
> 
> Atilano
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>