[Elecraft] K1 RF board DC checks failing

[Mike Clarke]

On Mon, May 18, 2009 at 2:49 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:
> Mike,
>
> U3 pin 6 is the output voltage of the 8 volt regulator - it is lower than
> usual, but not in excess of the regulator specs (+/-10%).  Pin 5 is an
> output from U3 and will depend on the voltage applied to pin 6.
> So bottom line - all is OK.

Hi Don,

Thanks for the response to what must seem like a trivial question to old hands!

It's good to know I'm not ignoring things now and saving trouble up for
when it's more difficult to debug :)

73,

-- 
Mike, M0PRL