[Elecraft] K2 receiver

[Don Wilhelm]

John,

Are you certain you have actually lost 3 dB of sensitivity.  Looking at 
the S-meter response at the S-9 level does *not* necessarily indicate a 
loss in sensitivity.
Make an MDS measurement to see if that indicates a sensitivity loss 
(that will be a valid measurement).  If the MDS is ok, then you may just 
have an S-meter alignment error.

You will have to put the KSB2 board and the KAF2 or KDSP2 back in to get 
audio through the K2 (or install the jumpers)

73,
Don W3FPR

John Chance-Read wrote:
> I am trying to find a fault in the receiver (I've lost 3 dB of signal) i.e. 50uV in only give a reading of 6 on the meter.
> So far no luck but I've now stripped off the SSB / 100W / 160 m / Dig Filter accessories to make it easier to find.
> I've linked W1, W2, and W3 but can some one advise me on other Plug/Sockets that need linking ?  Its a long time ago since I built it and the old brainbox isn't very good on the recall.
> John  G4BOU
>
>
>       
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.325 / Virus Database: 270.12.26/2110 - Release Date: 05/12/09 06:22:00
>
>