[Elecraft] K3 KPA3 Fan Upgrade Question

Joe Planisky jplan at jeffnet.org
Wed May 13 11:25:47 EDT 2009


Apparently not all K3s are created equal, thermally speaking.

On my K3, it takes about 2:45 of 20 wpm CW at 50 watts into a dummy  
load to raise the PA temp from 18C to 37C (the fan turn-on temp.   
Ambient temp is about 18C.)

73
--
Joe KB8AP


On May 13, 2009, at 6:24 AM, Ed Muns wrote:

> You're doing what?!
>
> For two years I've run my K3s in NAQP at 100 watts with high duty  
> cycle.  The fans seldom turn-on and the PA is barely warm.  If you  
> can out-design N6KR, I'd be amazed.
>
> Ed - W0YK
>
>
> ------Original Message------
> From: Brian Binkley
> Sender: elecraft-bounces at mailman.qth.net
> To: elecraft at mailman.qth.net
> Sent: May 13, 2009 05:11
> Subject: [Elecraft] K3 KPA3 Fan Upgrade Question
>
> Hello,
>
> I am currently in the process of upgrading the fans for the KPA3 100  
> Watt
> Amplifier module because the heatsink temperature gets too high for my
> liking. I am upgrading both fans to a fan with higher CFM output.  
> Last night
> I hooked both fans up to the KPAIO module to test and see if they  
> will work.
> When I am on fan power level one, the fans try to but are unable to  
> start
> up. I have to bump them to start them spinning. Power level two has no
> problem spinning them up. When I went to power level four and then  
> brought
> the power level to one, the fans did not have any problem continuing
> running. The fan specs can be found here
> http://www.sundialmicro.com/ipcqueen_dc_fan_606010_ball_bearing_3pin_2033_1199.html 
> .
> Is there any components that I can add in line to provide the  
> necessary
> power to start the fans up at power level one?
>
>
> Thanks
> Brian Binkley
> KD8CPF
> KD8CPF at gmail.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>
> Sent from my BlackBerry
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html



More information about the Elecraft mailing list