[Elecraft] Saving splits to memory

[David Ferrington, M0XDF]

Which section - since if you can miss it, so can we
73 de M0XDF, K3 #174
--  
The problem with being sure that God is on your side is that you can't
change your mind, because God sure isn't going to change His. -Roger  
Ebert,
film-critic (1942- )

On 12 May 2009, at 14:37, w8zn at comcast.net wrote:

> Please ignore this email.......................RTFM
>
> ----- Original Message -----
>
> From: w8zn at comcast.net
>
> To: elecraft at mailman.qth.net
>
> Sent: Tue, 12 May 2009 13:29:25 +0000 (UTC)
>
> Subject: [Elecraft] Saving splits to memory
>
>
>
> OK, I spent an hour last night trying to figure this out. Have the  
> latest firmware and wanted to take advantage of the new transverter  
> IF range to program a 222 repeater frequency for my repeater. Was  
> able to easily set 224.34 in VFO A and 222.74 in VFO B hit split and  
> it works great. However when I save to one of the 99 general purpose  
> memories, the split doesn't save. I've gone through all the release  
> notes and the manual and find nothing that says it should or  
> shouldn't save.