[Elecraft] K3 - Data A pitch

[Stewart Rolfe]

Lyle,

What I was looking for was being able to control the pitch when I hit the XFIL button, like in AFSK A and CW; in DATA A this centres on ~1500Hz. Presume this is a function of sidetone frequency.

However using HI/LO CUT works just fine and I can store this in one of the per mode filter pre-sets. Haven't checked though whether this pre-set will get overwritten by the AFSK A settings - normally use rtty/AFSK A in data but getting sorted for an RSGB data contest tomorrow evening in which the rules now mean you have to use both PSK and RTTY if you want to maximise your score.....

Thanks for the reminder about HI/LO cut.

73,

Stewart GW0ETF


--- On Mon, 11/5/09, Lyle Johnson <kk7p at wavecable.com> wrote:

> From: Lyle Johnson <kk7p at wavecable.com>
> Subject: Re: [Elecraft] K3 - Data A pitch
> To: gw0etf at btinternet.com
> Cc: elecraft at mailman.qth.net
> Date: Monday, 11 May, 2009, 10:40 PM
> > Seen this asked before but without response so does
> anyone know if it's possible to change the centre
> frequency of the audio in Data A?
> 
> Yes, just set the SHIFT and WIDTH controls to your liking.
> 
> > Also my (old) manual suggests you should be able to
> use the dual passband filter for rtty while in Data A but I
> assume this was a mistake?
> 
> 
> DATA:FSK or DATA:AFSK only.
> 
> 73,
> 
> Lyle KK7P