[Elecraft] XV144 with K3

[wayne burdick]

Hi Johnny,

- turn the sub RX on
- set VFO A to the desired frequency and FM mode
- tap A>B twice to copy all A settings to B, then move B to the desired 
frequency
- use BSET to make sure the sub's antenna is set to MAIN, then exit BSET
- set up squelch for main and sub (see SQ MAIN and SQ SUB menu entries)

This should do it. You should use the latest firmware release (3.11).

Let me know if you're still not getting the expected results.

73,
Wayne
N6KR


On May 3, 2009, at 4:58 AM, Johnny Siu wrote:

> Hello Group,
>  
> My K3 is equipped with KRX3 and KXV3.  When I operate at 145.650mhz 
> repeater channel with XV144, could anybody advise what is the right 
> setting so that I can monitor both the uplink 145.050 and downlink 
> 145.650mhz at the same time?
>  
> I just don't know how to configurate the K3 so as to monitor the 
> uplink using the KRX3 subreceiver.
>  
> BTW, how I can use the S meter to read signal strength of the uplink 
> and downlink?
>  
> Thank you for your help in advance.
>  
> 73
>  
> Johnny Siu VR2XMC
>
>
>       Yahoo!Ïã¸ÛÌṩ¾WÉÏ°²È«¹¥ÂÔ£¬½ÌÄãÈçºÎ·À¹ ºÚ¿Í! ՈǰÍù 
> http://hk.promo.yahoo.com/security/ Á˽â¸ü¶à!
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

---

http://www.elecraft.com