[Elecraft] Width of AM filter

[n6ax at speakeasy.net]

Last time I looked at one of the filter boards there seemed to be a substantial quantity of components....not a simple carrier as 
in the Inrad boards or those for the Kenwood plug-in filters.

The components' function, I think, is to tell the radio that the appropriate filter is installed for the desired (AM or FM) 
operating mode. As a result, any "blank" board for one of those operating modes would need to have  a certain minimum component 
population to serve that purpose. It would, as a result, not be a $10.00 (only) board.

I trust I will be corrected if I am wrong here.

Regards

John, N6AX
K3 # 567








On Fri Mar 27  4:48 , Barry N1EU  sent:

>
>
>
>I was going to suggest an LC filter for non-critical work.  If Elecraft would supply "replacement" carrier boards with the pin 
sockets either mounted or available it would be nice.
>
>
>Inrad has supplied these blank boards at a reasonable price ($10?) in the past for various radios.
>
>Barry N1EU
>
>(if this message shows up in html format, it's Nabble's fault)
>
>-- 
>View this message in context: http://n2.nabble.com/Width-of-AM-filter-tp2540204p2543885.html
>Sent from the Elecraft mailing list archive at Nabble.com.
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html