[Elecraft] How long to complete K3 "master reset?"

[Dick Dievendorff]

Pressing and holding the Power button forces the K3 MCU into a "boot load"
state, not "master reset".  You now need to reload the MCU firmware.

Or you can remove power from the K3 (I pull the power connectors off the
back of the radio), wait 20 seconds or so, and then plug it back in.  

You may still have firmware loaded.

But the radio is going to sit in MCU LD state until it either receives a new
firmware load or you cycle the power.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Brian Machesney
Sent: Monday, March 23, 2009 7:17 AM
To: Elecraft reflector
Subject: [Elecraft] How long to complete K3 "master reset?"

I pressed and held the K3 power switch until the "MCU LD" message appeared -
that was over a half-hour ago. How long should this take to complete?

Trying to solve the "low sub RX audio" problem.

Brian K1LI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html