[Elecraft] KIO2, KPA100 - is SWR value available via RS232?

[David Fleming]

> After connection at 4800 baud,
> DS;  returns the frequency
> SW20;  enters tune mode (I changed the tune mode to CALS to
> have enoogh time for the following command)
> DS;  returns a "?", although I see the SWR on
> K2's LCD

Hmmm. DS; may not work during transmit on the K2. My K2 is not hooked up, so I cannot test. Could someone please confirm whether DS; works during transmit on the K2. If not, this method will not work. :(

David, W4SMT


--- On Sat, 3/14/09, ub5_073_oleg <ub5_073_oleg at flashmail.com> wrote:

> From: ub5_073_oleg <ub5_073_oleg at flashmail.com>
> Subject: Re: [Elecraft] KIO2, KPA100 - is SWR value available via RS232?
> To: elecraft at mailman.qth.net
> Date: Saturday, March 14, 2009, 4:14 PM
> David, thanks for your reply!
> 
> I gave it a try in a terminal program.
> 
> After connection at 4800 baud,
> DS;  returns the frequency
> SW20;  enters tune mode (I changed the tune mode to CALS to
> have enoogh time for the following command)
> DS;  returns a "?", although I see the SWR on
> K2's LCD
> 
> Am I doing something wrong? My firmware is 2.04P  1.09
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list:
> http://www.qsl.net/donate.html