[Elecraft] K2 and 30L1

[Guy Olinger, K2AV]

I can't locate it but I remember something about length of the cable from 
the driving rig to the 30L1.  It should be short. Also if the 30L1 is acting 
squirrely, you should not be driving the 30L1 through the ATU assuming your 
K2 installation has it. You may also have a problem with the 811A's if at 
one time the input SWR was lower.

As to keying the transmit relay circuit in an unmodified 30L1, that amp 
has -170 volts on that lead, you are keying cutoff bias. A relay closure or 
a transistor keying interface circuit built specifically for that high 
negative voltage is required.

73, Guy.

----- Original Message ----- 
From: "syd smith" <sydmaryj at msn.com>
To: <elecraft at mailman.qth.net>
Sent: Saturday, March 14, 2009 2:20 PM
Subject: [Elecraft] K2 and 30L1





Darned if I can find the "sink" specifications of the PA KEY OUT ... so I 
brewed up an external T-R relay.  Better safe than sorry.  Anyone directly 
switching a Collins 30L-1?



Then I fired up the amp and tuned the 30L-1 with low power out from the K2; 
but when I advanced the K2 to about 20 watts out, the plate current of the 
30L-1 zipped up to 800 MA.....yeow, the 811s wont last long at that rate. 
Now I know their has to be a lot of people using this combination of 
equipment ... any comments?



I noticed the swr was high at 1.8:1 so the tuned input circuits of the 30L1 
needs tweaking;  and of course, the ALC is open.  The 30L-1 works fine with 
my S-Line by the way.



Syd - WB4W

_________________________________________________________________
Express your personality in color! Preview and select themes for Hotmail®.
http://www.windowslive-hotmail.com/LearnMore/personalize.aspx?ocid=TXT_MSGTX_WL_HM_express_032009#colortheme
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html