[Elecraft] K3 Upgrade Kit Question

[Eric Swartz - WA6HHQ, Elecraft]

Hi Roy,

You are OK. Rev B -IS- the new KIO3 Digital Remote I/O board. (Same as 
supplied with the REMIOUPGD kit.)

L1 is not jumpered. It is replaced with a zero ohm resistor on this board.

73, Eric  WA6HHQ
-----


Roy Morris wrote:
> I have the Rev B E850235 K3 KIO3 Digital I/O PCB installed in my K3.  Choke L1 has NOT been jumpered.  I sent an email to Elecraft at Info at Elecraft.com asking if L1 should be jumpered.  I never received a reply.  Roy Morris  W4WFB
>
>