[Elecraft] K3 Transmit thru Line-In

[Richard Ferch]

Bud,

I suspect your Line In level control may be set to zero. This cannot be
adjusted while MIC+LIN is on. In order to adjust the Line In level, you have
to set MAIN:MIC SEL to LINE IN. Then adjust the LINE IN level using the MIC
control. After the Line In level is set to an appropriate level, you can
then set your MAIN:MIC SEL back to RPH and turn MIC+LIN back ON. See the
page in the manual on the Main menu functions (p. 52).

73,
Rich VE3KI

W3LL wrote:
>
> I can't get any transmit audio via the Line-In connector.
>
> Connecting the Mic cable to the rear panel MIC connection produces good
transmit \
> power and audio.
>
> I know audio is coming from the sound card output because it also drives
the computer \
> speaker via its line in  connection.
>
> I tried moving the Mic connector from the rear panel MIC to the Line-In
rear panel \
> position. This still would not  produce K3 SSB output.
>
> Moving the Line-In connector to the MIC rear panel connector produces good
transmit \
> power and audio.
>
> The TX lights each time but no output via Line-In
> The K3 is in LSB mode.
> TX TEST is in normal.
> MIC SEL is RPH
> MIC + LIN is ON.
> MIC Gain is 30
> Comp is 22.
>
> Why can't I transmit thru the Line-In connection?
>