[Elecraft] hot glue K2 toroids?

[David Cutter]

Dow Corning make a range, 3140 is one I've used.  It's very expensive 
compared to the acetic acid bathroom sealant variety.

David
G3UNA

----- Original Message ----- 
From: "SidShusterman" <k3sx at comcast.net>
To: <elecraft at mailman.qth.net>
Sent: Monday, March 02, 2009 10:21 PM
Subject: Re: [Elecraft] hot glue K2 toroids?


>I was asked to make this information to the group.
> Sid
>
>
>  Sid,
>
>  There is a variant of RTV that is OK on circuit boards. It is made by MG
>  Chemicals specifically for electronics. It is catalog number 1035, and
> comes
>  in 85ml tubes. We buy it from Allied (www.alliedelec.com), stock number
>  661-0780. A datasheet is available at
>  http://www.mgchemicals.com/products/1035.html.
>
>  It is non-corrosive and works very well to seal toroids to a PC board.
>
>  Please let others know.
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html