[Elecraft] K3 VFO tuning hash

[Graham Kimbell (G3TCT)]

This noise was previously reported under the title "K3 Tuning encoder pulses
and birdie problem"
In my case it is only noticeable at the low end of 28MHz when there is a low
noise level from the antenna or with a dummy load attached.
Wayne suggested using the noise blanker on a low setting like t1-5, also
tightening screws and tmp cables may help.  In my case it seemed to get
better when I installed the KRX3, but maybe cos I tightened up the screws
and cables.
HTH
Graham

----- Original Message -----
From: "John Lawrence" <jsl at hughes.net>
.
> What I've discovered and reported to factory tech support is a very
noticable hash noise while in the receive mode with any bandwidth centered
around 28.000 MHz to 28.050 MHz.