[Elecraft] K3 -> Aux I/O to W9XT BCD-10 Band Decoder

[Joe Subich, W4TV]

Eric, 

As suggested before, the reflector archives are your friend: 
  http://mailman.qth.net/pipermail/elecraft/2009-May/111149.html 

73, 

   ... Joe, W4TV 
 




> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Eric Rosenberg
> Sent: Saturday, June 27, 2009 10:01 AM
> To: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] K3 -> Aux I/O to W9XT BCD-10 Band Decoder
> 
> 
> Thanks to all who responded!
> 
> Next Question:
> 
> I need a "Y" cable from that ACC I/O Port:  DB-15M to TWO 
> DB-15F.  The 
> ones I've seen are all VGA splitters and missing PIN 9, which is the 
> BAND 2 output.
> 
> Does anyone know of a source of a splitter than has Pin 9 
> installed? (I 
> need pins 3,9,13 and 14)
> 
> Thanks,
> 
> Eric W3DQ
> Washington, DC
> 
> 
> >> e band decoder output of the K3 into a Unified
> >> Microsystems (W9XT) BCD-10 Band Decoder / Antenna Selector.
> >>
> >> I'm not sire which of the K3 four outputs go to the BCD-10's four 
> >> inputs.
> >>
> >> Any help is appreciated!
> >>
> >> Eric W3DQ
> >> Washington, DC 
> >> ______________________________________________________________
> >> Elecraft mailing list
> >> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> >> Help: http://mailman.qth.net/mmfaq.htm
> >> Post: mailto:Elecraft at mailman.qth.net
> >>
> >> This list hosted by: http://www.qsl.net
> >> Please help support this email list: http://www.qsl.net/donate.html
> >>
> >>   
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html