[Elecraft] Heil Proset-k2 with K3 - Settings please for newbie

[Ron D'Eau Claire]

Sounds like you didn't get the current instructions Dale and I don't find
them on the web site either!

I'll send them to you off the reflector. 

Ron AC7AC



-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dale Harding K7DNH
Sent: Friday, June 26, 2009 7:16 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Heil Proset-k2 with K3 - Settings please for newbie


Newbie question - 

I dont want to take the chance to fry something. I want to start using the
Heil Proset-K2 I ordered with the K3 - but a bit unsure of exactly how to
set it up. THe instructions that came with it are mostly for installing the
necessary kit into the K2. 

I searched thr reflector for the setting to use and came up with opposing
views... the majority stated  if using the front panel use the following:
Use the adapter supplied and plug in both connectors and then into the k3
front panel,  FP Low - with bias on, Vox On, VOx gain = 50, antivox=00

To use the rear panel - do not use the adapter " and plug the connectors
into the repar panel jacks - well - exactly which ones?  The only  two that
the large one will fit is the paddle and the key.  

Apprecaite your help folks,

Dale

K7DNH
-- 
View this message in context:
http://n2.nabble.com/Heil-Proset-k2-with-K3---Settings-please-for-newbie-tp3
164969p3164969.html
Sent from the Elecraft mailing list archive at Nabble.com.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html