[Elecraft] Auto-notch not remembered when switching back to SSB

[Bill W5WVO]

I have VFO A set up for SSB and VFO B set up for DATA A. Since auto-notch is inappropriate for digital modes, it is automatically disabled when I switch to VFO B. However, when I switch back to VFO A (SSB), auto-notch is forgotten and I have to manually re-enable it. I would like it to remember the auto-notch state.

A corollary example: If I set a manual notch in SSB mode and switch to DATA A mode, the manual notch (which is deemed OK for use in DATA A mode) is automatically retained in DATA A, which hardly seems appropriate. (Sound card data modes generally should be run with a flat passband.)

More generally, then: Any transmission mode (a) should remember its settings when switching out of and back to the mode, and (b) should not port its settings to other transmission modes. 

I'm wondering if this general principle is already being implemented along with saving equalization settings per-mode. If not, can it be?

Bill W5WVO