[Elecraft] K3 - N1MM, footswitch and ESM action

[GW0ETF]

This is probably an N1MM issue but thought someone on here may have something
useful to say....

I finally got round to properly setting up the dual transceive SO2V on my K3
for N1MM and it seems to work a treat. I can now have the 2 entry windows
open with VFO A running and B set for S&P on the sub receiver frequency;
<CTRL Left/Rt Arrows> flick between A and B (invoking SPLIT for B to tx on
the sub qrg) and while running I can hit <\> to put an S&P call in the VFO B
box to check for a dupe etc.

Just one minor annoyance/oddity; I use ESM all the time (mainly cw here) and
have a footswitch on an LPT port set for "ESM ENTER". But it appears the
footswitch only acts on VFO A which is normally set up for running. So if
I've swapped to VFO B to S&P someone and then hit the footswitch to send my
call (F4) the focus swaps back to A and I end up calling CQ on my run
frequency instead. No problems if I use the keyboard ENTER key. I've tried
changing the LPT Radio number from 1,2 to Both etc but no difference.

Any ideas folks? I'm assuming it's an N1MM issue so it's also gone onto the
N1MM Yahoo board.

73,

Stewart Rolfe, GW0ETF




-- 
View this message in context: http://n2.nabble.com/K3---N1MM%2C-footswitch-and-ESM-action-tp3132037p3132037.html
Sent from the Elecraft mailing list archive at Nabble.com.