[Elecraft] K3 Load fails

[Dick Dievendorff]

As I recall there is a new FPF version that you may need to put into  
the same firmware folder as your new MCU version.

Dint try to mix...

Dick, K6KR



Sent from my iPhone

On Jun 18, 2009, at 6:05 PM, "Paul Ferguson" <Paul at PaulFerguson.us>  
wrote:

> I have K3 #757. It was running fine on firmware 3.14. I tried to  
> load the 3.19
> Beta version. The MCU load completed OK. It then failed on the FPF  
> load with
> the following messages:
>
> ---------------
> FPF firmware file hfpf0100.hex verified
> Erasing flash memory
> Sending firmware file hfpf0100.hex to FPF
> Send FPF firmware failed at load address x03C0
> GetLastError returns 0xe2000012 "NACK retry limit has been  
> exhausted" state 30
> FPF firmware load failed
> ---------------
>
> I powered off and tried again with the same results. I downloaded  
> 3.19 again
> and got the same results. I then tried several times to reload my  
> saved version
> 3.14, but got the same error. The load address location is varies. I  
> have seen
> x03C0, x0380, and x0350.
>
> I am using Elecraft Utility ver 1.2.3.18 on Windows XP with the  
> Elecraft USB to
> RS232 cable.
>
> Any idea what to do next?
>
> 73,
> Paul
> K5ESW
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html