[Elecraft] Tracking VFOs

[wayne burdick]

Hi Bill,

Just hold SUB until you see "LINK" displayed (about 1/2 second). The 
kHz decimal point of the VFO B display will flash as a reminder that 
the VFOs are linked. (If you continue to hold SUB, it will turn on the 
sub receiver and put the rig into diversity receive mode.)

Once the VFOs are linked, you can tap A->B, then offset VFO B as 
desired. VFOs A and B will track at the established offset until you 
unlink them.

73,
Wayne
N6KR

On Jun 10, 2009, at 4:46 PM, Bill W5WVO wrote:

> I seem to recall some discussion about this a while ago, but can't 
> locate it now -- Is there a way to make the two VFOs track each other 
> by a certain offset? In other words, I set VFO A to 50125.0 and set 
> VFO B to 50125.7, and when I turn the VFO A knob, both VFOs tune, 
> maintaining the 700 Hz offset? If this is not possible with one RX is 
> it possible using the KRX3?
>
> Bill W5WVO

---

http://www.elecraft.com