[Elecraft] troubleshooting elecraft k1 voltage checks

[E Neubauer]

Hello:
I am in the midst of building the rf board for the K1.  All went well until page 30 in the manual.  
I performed the voltage checks and the only one that works is the one at p1 pin 15.  The others read "zero" on my DMM.  I rechecked all soldering - no solder bridges or cold joints.  I went back to the beginning of the rf board assembly and double checked every component's installation and orientation - all fine.

Has anyone got suggestions about where to start to diagnose the problem?   Thanks very much.
Ed
_________________________________________________________________
Windows Live™ SkyDrive™: Get 25 GB of free online storage.
http://windowslive.com/online/skydrive?ocid=TXT_TAGLM_WL_SD_25GB_062009