[Elecraft] K3 power jump on 6m

[Stephen Prior]

If I change the power output on 6m it immediately jumps from 8W to 13W and
then on to 120W as usual.  So I cannot dial up any power between 8W and 13W
on 6m.  I have reloaded the (latest) firmware and recalibrated the
transmitter gain using the utility.  On the first run through at 5W the
procedure stopped with an error at 20m where the utility did not set the
power to 5W but 5.2W.  I rather stupidly did not write the error message
down.  I then continued and successfully calibrated at all bands on 50W- now
it works all the way through on 5W too.  I can't see how that could affect
the 6m power jump however.

I thought that I had read about this just recently but a search of the
archive did not bring it to light.

I'd be grateful for any advice.

Thanks and 73

Stephen G4SJP