[Elecraft] K3: Mixer Commands?

[Don Wilhelm]

I located one post from Lyle on the subject.  I am certain it is not all 
of the 'magic', but perhaps it will help until the commands are 
integrated into the MCU code so the user interface is much smoother.
I have copied  Lyle's post at the end of this email.

73,
Don W3FPR

Dave Zeph wrote:
> At one time there were several messages on how to set up the K3 Mixer to get
> various combinations of MAIN and SUB receiver Audio out to Both, or Specific
> Ears.
>
>  
>
> At the time I though I had an understanding of the syntax of the Command -
> but I don't.
>
>  
>
> Could someone provide the complete syntax of the command - indicating the
> different fields, and the values of those fields for the various
> combinations of Audio Mixing??  I don't find anything in the Programmer
> Reference and the original message posting (if I could find it) was a bit
> confusing.
>
>
>
> Thanks and 73, Dave, W9ZRX
>
>   
>

The adventurous may try the following.  These commands do not stick 
through power cycles, and may not remain through mode changes or other 
commands.  In other words, the radio may revert back to normal operation 
at any time  :) 

If you want Main Rx in both ears and leave the Sub Rx in the right ear, 
go to the command tester and type:

!bed7;

If you want the Sub Rx in both ears and the Main only in the left, type:

!bef9;

Be sure SPKRS+PH is OFF, or SPKRS=2, with these commands.

Enjoy!

73,

Lyle KK7P