[Elecraft] K3 filter/DSP selection?

[K4IA at aol.com]

Chuck

Properly set up in the menus, you  just dial the bandwidth you want and the 
roofing filters automatically kick in  where they are called for.  One knob 
to twist and it all happens with a  graphical representation on the screen. 
 Couldn't be  easier.

Buck
k4ia
K3 #101

In a message dated 6/4/2009  8:07:01 P.M. Eastern Daylight Time, 
callen1155 at yahoo.com  writes:

Hello,

I have a K2 and am considering selling it to fund a  bare bones K3. 
However, what I find awkward about the K2 is the way the cw  filters (I only do cw) 
and the DSP filters are selected ... too much button  pushing to get the 
bandwidth I need and if I go past the best setting I have to  scroll all the 
way thru again. Plus no easy way to activate DSP noise reduction  unless I 
have it pre-programmed.

So I'm trying to understand how this is  accomplished on the K3. I'd love 
to have a knob to control the filter and DSP  bandwidth, a pushbutton to 
activate DSP, and another pushbutton to activate DSP  noise reduction. I've 
looked thru the K3 operating manual but am not exactly  following it.

Could someone please shed a little light on how the K3  performs this and 
if they find it user friendly?

thanks in  advance.
chuck
af4xk




______________________________________________________________
Elecraft  mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:  http://mailman.qth.net/mmfaq.htm
Post:  mailto:Elecraft at mailman.qth.net

This list hosted by:  http://www.qsl.net
Please help support this email list:  http://www.qsl.net/donate.html  

**************Limited Time Offers: Save big on popular laptops at Dell 
(http://pr.atwola.com/promoclk/100126575x1221354145x1201369495/aol?redir=http:%2F
%2Fad.doubleclick.net%2Fclk%3B215221161%3B37268813%3By)