[Elecraft] K3: machined concentric knobs from Mouser

[Brett Howard]

Aluminum isn't all that heavy...

On Wed, 2009-07-29 at 21:19 -0500, Bill wrote:
> I also wonder how much weight they add.
> 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Brett Howard
> 
> The word is inexpensive... not cheap!  Those look really nice!  I was
> just sitting here wondering if there was a knob that would fit over the
> shift, width, speed, and pwr knobs.  I'm not so sure I'd want to mess w/
> them too much though as I'd not want the spacing between them to get too
> terribly much smaller.  They work well as they are... But that does look
> quite good...
> 
> ~Brett
>