[Elecraft] K3 - Cockpit erro

[Joe Planisky]

Hi Paul,

I ran into the same situation for the first time last weekend.  You  
probably hit one of the M1 - M4 buttons while the TX EQ config item  
with active.  To restore your CW memories, tap REC, then tap the  
memory switch you want to restore (M1 - M4), then tap REC again.

This is explained at the bottom of page 21 in the Owners Manual (rev  
D4) in the section titled "Programmable Functions".

73
--
Joe KB8AP

On Jul 22, 2009, at 6:57 AM, PAUL VANOVEREN wrote:

>      Yesterday, when fooling around in the Config:Menu, and  
> experimenting with the TX-EQ, I must have hit some buttons by  
> mistake. My CW memories, set up in the Elecraft Utility, no longer  
> work as before. Now the TX EQl info shows up when I push on the the  
> M1-M4 message buttons... Can someone tell me how to clear the  
> preferences that I seem to have set up inadvertantly. Do I have to  
> do some sort of soft reset ?? I can not find the information in the  
> manual. Running 3.11 firmware, K3 is serial no. 758...
>      The CW memories in the Utility have not changed, they just will  
> not run.
>
> Paul
> NF8J
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html