[Elecraft] KAT2 Power cal

[Don Wilhelm]

Tom,

Yes, you can use the RF probe.  It *should* be OK up to a max of 20 
watts measuring across a 50 ohm dummy load.  The 1N34A diode is rated at 
45 volts peak reverse voltage, so if you exceed 30 volts RMS (the RF 
Probe reads in RMS volts), you are nearing the limit.

The accuracy of your measurement depends on the accuracy of your dummy 
load.  It would be wise to check it with an antenna analyzer at the 
frequency you will be using for calibration (40 meters is preferred)

73,
Don W3FPR

Tom Campie wrote:
> Hey guys, I'm going to finish my KAT2 tonight and I need to calibrate the
> power and all that stuff.  I have a 50 ohm dummy load so the SWR cal is good
> but I dont have a power meter.  Can I use the RF probe that was made during
> the construction of the K2?  If so, is there some documentation somewhere on
> how to do that?  (note -I did not build my K2 so I have not used the
> integrated test equipment)
>
> Tom W0EA
>   
>