[Elecraft] Question on KRX3 Installation

[David Y.]

Grant,

I think that "equates" to an open circuit.  By the way, congrats on having a 
meter that reads that high!

Dave W7AQK


----- Original Message ----- 
From: "Grant Youngman" <nq5t at tx.rr.com>
To: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Thursday, July 16, 2009 7:33 PM
Subject: [Elecraft] Question on KRX3 Installation


> In errata C-7 dated March 15, 2009, page 1, there are instructions to
> cut two traces in the area to the right of D40 on the RF board.
>
> The instructions indicate that these cuts should read open circuit.  I
> read about 14M ohms on both -- and I have cut them cleanly.
>
> Is this right?  Am I missing something?
>
> Thanks ... Grant/NQ5T
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html