[Elecraft] K2: Scanning 60m with K60XV

[Randy Moore]

I found my problem.  All the 60m frequencies must be setup in VFO A.  
The instructions say this at the beginning (though in parenthesis), but 
I guess I skipped over it!  Now all is well.

73,
Randy, KS4L

Randy Moore wrote:
> Just got the K60XV installed in my K2 (#337).  All my firmware is 
> current.  I can access and use the 60m frequencies just fine, and I 
> programmed the first 5 memories for the allowed channels. 
>
> When I attempt to enable channel hopping I run into some "issues," 
> possibly related to my misunderstanding of how this works.  If I edit 
> "rATES" to be "CH SC", channel hopping doesn't work.  Tuning VFO A 
> continues to modify the frequency in the normal way.  If I edit "rATES" 
> to be "CH SC-TN" (manual tuning enabled - not really sure what this 
> means), channel hopping works and the VFO cycles through the first 5 
> memories that I have set to 60m channels just like I expected. 
>
> Under neither of the above conditions will scanning work.  If I initiate 
> scanning by "holding" "RCL", then "holding" the appropriate channel 
> number (the one "STOREd" after editing "rATES), the MHz decimal point 
> blinks as is should, the displayed frequency shifts about +20 hz, the 
> receiver mutes for a few seconds, then the frequency never changes 
> again.  The receiver will periodically mute for a few seconds, but no 
> further scanning happens.
>
> Any advice or corrections would be appreciated!
>
> 73,
> Randy, KS4L
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>